>> Blue Red
home > D9 questions
D9 questions

1.How to assemble the D9?

2- How to replace the auto leveling prob and adjust the prob for right distance?

 

3- How to install D9 LCD Firmware and motherboard firmware?

 Instruction        Video

4- How to calibrate D9 Screen?

 

5- How to Level D9 bed?

 

6- How to replace D9 motherboard?

 

7-How to Replace D9 Print bed Wheels?

 

8 How to insulate the splitter/inter board by washers?

      

9. How to push the D9 rubber wheel back onto the bearing?

  

10. How to replace wheels?

11. How to Fix Z offset issue if nozzle is too low that dig into bed?

 

12. How to Replace D9 PTFE tube?

   


13. How to Replace D9 Hot end?  Full Metal hot end( work at 260-300°C)/ PTFE hot end(180-260°C).

       

14. How to Replace D9 Heating Tube?

15. How to Replace D9 Thermistor?

 16. How to change D9 500 Nozzle Size in Cura?

 

17. How to insert SD card into D9? 

 18. How to Flash Firmware and Print through USB link?

19. How to replace the splitter board( inter-board)?

 20. How to add new Cura into Wanhao Cura 16.021?

 21. How to Upgrade D9 with RIB (Strengthen bars)?

                       

Notice:D9 300 and 400 have the same size Ribs and share same Strengthen Bar for installation. Only D9 500 has a different one.

On your D9 400 You need to tighten the Ribs on where it stands using the bolts.

   

22. How to Troubleshoot Z axis stuck?

23. D9 Power Break

24. BL Touch Error

25. D9 Print bed Carriage

26. D9 BLTouch doesn't Work? 

 

 

 

  

[1] [2]  下一页